Ant Test Tube Setup: How to Make One Step by Step

An ant test tube setup is a test tube with water held behind a cotton plug, used to house a queen until her first workers arrive. Fill about a third of the tube with water, push a cotton ball down until it touches the water and is damp but not dripping, add the queen, and close the opening with a second, looser piece of cotton.

What you need

  • A glass or clear plastic test tube, commonly 16 mm wide and 150 mm long (about 5/8 by 6 inches)
  • Clean cotton balls
  • Clean water, ideally bottled or filtered
  • A dark place or a red or opaque cover

Steps

  1. Add water. Fill the tube about one third.
  2. Seat the first cotton plug. Push a tight cotton ball down until it meets the water. The face of the cotton should be damp. If water runs past it, the plug is too loose.
  3. Add the queen. Let her walk in. Avoid handling her with fingers.
  4. Close the opening. Use a looser piece of cotton so air can pass.
  5. Keep it dark and still. Lay the tube flat in a drawer or cover it. Vibration and light stress a founding queen.

Tube size by ant size

Ant size Typical tube
Small species 10 to 13 mm wide
Medium species 16 mm wide, 150 mm long
Large species 18 to 20 mm wide, 180 mm long

Common mistakes

  • Checking too often. Once a week is enough during founding.
  • Flooding. A loose water plug lets water into the living space.
  • Feeding a claustral queen. Fully claustral queens live on their reserves until workers arrive. Semi-claustral species are different and do need food, so identify your species.
  • Moving out too early. Wait for roughly 10 to 25 workers.

When and how to move to a formicarium

When the colony is large enough, or the water is nearly gone or the cotton is moldy, connect the open end of the tube to a nest. Keep the nest dark and the tube in light, and the ants usually move on their own within days. Our formicarium kits have 10 mm entrance holes that accept standard connection tubing.

Frequently asked questions

How long can ants stay in a test tube?

Often several months, as long as there is water and the cotton stays clean. Many colonies spend their whole first season in one.

What if the cotton turns moldy?

Connect a fresh test tube setup opening to opening, darken the new one, and let the colony move over.

Should the test tube be warm?

Room temperature works for many species. Gentle warmth can speed up brood development, but avoid direct sun and condensation.